Blog

Drainage Ditch on Your Property: Digging, Lining and Maintenance

Water's got to go somewhere. When it keeps cutting across your yard, washing out the gravel drive, or sitting in the same low spot every spring, a drainage ditch on your property may be the simplest way to give it a path.

We're Josh and Mark Collier with Middle TN Grading & Clearing (MTGC). Here's a plain look at when a ditch makes sense, how one gets dug and lined, and how to keep it doing its job.

When Does a Property Need a Drainage Ditch?

A ditch is worth a look if you see any of these:

  • Water runs across the yard or driveway every time it rains hard
  • A low spot holds water for days
  • Runoff from a neighbor's hill or the road keeps heading your way
  • Your drive or the ditch in front of the house is washing out
  • A field or pasture stays too wet to use

Sometimes a ditch isn't the whole answer. Regrading, a culvert under the drive, or a French drain may fit better, and a lot of the time it's a mix. The best first step is to walk the property during or right after a good rain and watch where the water actually goes.

How a Drainage Ditch Is Dug

A ditch looks simple, but most of the work is in the planning.

Start with the outlet. Before any dirt moves, you need to know where the water will end up. It needs a safe place to go: a road ditch, an existing channel, a low area on your own land, or a culvert. Sending more water onto a neighbor's property can cause problems, so the outlet comes first.

Get the grade right. The ditch has to fall steadily from start to finish. Too flat and water sits, grows weeds and silts in. Too steep and fast water starts cutting the bottom and sides. On steeper ground, a tougher lining (more on that below) or small rock checks can help slow the water down.

Shape it, don't just trench it. The USDA's Natural Resources Conservation Service describes a grassed waterway as a channel with a broad, shallow cross section that carries water to a stable outlet, and its Grassed Waterway standard (Code 412) calls for side slopes flatter than 2 to 1 (two feet across for every foot of drop), flattened further where mowing equipment needs to get in. In plain terms: gentle sides and a wide bottom, not steep straight walls. A shallow, grassy version is often called a swale.

Depth depends on the water. How deep and wide a ditch needs to be comes down to how much ground drains into it and what's around it. A ditch catching runoff off a big hillside needs more room than one moving water around a backyard.

Call 811 first. Before any digging, contact Tennessee 811 by dialing 811 or going to tenn811.com. Per Tennessee 811, a normal locate request needs at least three working days' notice, not counting weekends and holidays. Calling gets your underground utility lines marked for free. Utility companies don't mark private lines, like a line you ran to a shop or a well.

Lining Options

The lining is what keeps the ditch from eroding away. The right choice depends on how much water moves through it and how fast.

  • Grass. Good for gentle slopes and lighter flows. It looks natural and is easy to mow. New grass needs protection until it's established; the NRCS Code 412 standard lists things like fabric or rock checks and runoff diversion for that.
  • Erosion control matting. Erosion control fabric laid over seed helps hold soil and seed in place until the grass roots in. For tougher spots, NRCS's Lined Waterway or Outlet standard (Code 468) includes synthetic turf reinforcement fabrics as a permanent lining.
  • Riprap. Rock placed in the ditch for spots where grass alone won't hold. The NRCS Code 468 standard points to linings like this for concentrated runoff, steep grades and highly erosive soils, with riprap side slopes no steeper than 2 to 1. Where soil could wash out through the rock, it calls for a geotextile (filter fabric) or bedding layer underneath.
  • Stone. Smaller washed stone can work in lower-flow ditches or as a decorative "rock ditch" near the house. For harder flows, ask whether riprap is the better fit.

Many ditches use more than one: grass along the gentle stretches and rock where the water speeds up or comes out. When we line a ditch with rock, we haul the stone straight from the quarry and put it to work.

Keeping Your Ditch Working

A ditch isn't a one-and-done job. A little upkeep goes a long way:

  • Check it after big storms. NRCS's Code 412 standard says to inspect grassed waterways regularly, especially after heavy rains, and repair damaged spots right away. Look for washed-out spots, fallen limbs or rocks that moved.
  • Keep it clear. Leaves, trash and brush slow water down and cause backups. Pay extra attention at culvert ends.
  • Mow grass-lined ditches. Keep grass healthy but not overgrown.
  • Fix small erosion early. A little cut in the bottom becomes a gully fast if it's left alone.
  • Watch for silt. If sediment builds up, the ditch loses depth and may need cleaning out.

Rules and Permits in Tennessee

Rules depend on where you are and where the water goes. If your ditch will tie into a road ditch, empty into a creek or stream, or the work disturbs a larger area of ground, there may be city, county or state requirements. We didn't want to guess at those for you here: check with your county or TDEC (Tennessee Department of Environment and Conservation) before you dig, and check with your city if you're inside city limits. Ditches along a county or state road may also need an OK from whoever maintains that road.

What Drives the Cost

We price a ditch after we've seen the property. What moves the cost: how long and deep the ditch is, how much rock we hit, which lining it needs, how easy it is to get equipment in, whether culverts are part of it, and any permits. Cost varies widely with site conditions, so call (931) 458-1500 for a free estimate.

When to Call a Pro

A small backyard swale can be a weekend project. It's time to call someone with equipment when:

  • Water is threatening your house, drive or outbuildings
  • The ditch needs to tie into a road ditch, culvert or creek
  • You're hitting rock or heavy clay
  • The slope is steep enough that erosion is a real risk
  • You're not sure where the water can legally go

We work across Middle TN, including around Spring Hill, Franklin, Brentwood, Nolensville and Murfreesboro, and we'll tell you straight whether a ditch, regrading, a culvert or a drain is the right fix.

Frequently Asked Questions

Can I dig a drainage ditch on my property myself? For a short, shallow swale, sometimes. Getting a steady slope and a safe outlet are the hard parts. Contact Tennessee 811 at least three working days before digging (it's free), and check with your county or TDEC if water will head toward a stream or road.

What's the best liner for a drainage ditch? Grass with erosion matting works for gentle flows. Riprap or stone fits steeper or faster spots. Many ditches use both.

Can I put rocks in my drainage ditch? Yes. Rock is a common lining where water moves fast. Rock sized for the flow and laid over filter fabric holds up best. A pro can size it for your ditch.

How often should a ditch be cleaned out? There's no single schedule. Check it after big storms and clear debris and silt when you see it building up.

Let's Look at Where Your Water Goes

You can read more on our culverts and drainage page.

If water's giving you trouble, call Josh or Mark at MTGC, (931) 458-1500, or request a free quote at middletngrading.com. We're licensed and insured, and we'll come take a look on site and tell you straight what will fix it.

Get a free quote

← Back to the blog

Call (931) 458-1500